Blizzard hotstik 5 cob Bedienungsanleitung PDF herunterladen (Seite 11)

Page 11

EachwiCICLE

acts as both a transmitter and a receiver, depending on whether

a DMX source is applied to the integral XLR connector. This is an extremely

powerfulfeatureofthesystem,however,italsorequires1pieceofduediligence,

andthatistheremovalofextraneousDMXsignalsfromyourlightingrigBEFORE

proceeding.

SO: BEFORE DOING ANYTHING ELSE, YOU SHOULD DISABLE ANY BUILT-

IN PROGRAMS IN THE FIXTURES YOU WISH TO CONNECT AND/OR SET

THEM AS SLAVES PRIOR TO RETURNING THEM TO DMX MODE (IF AP

PLICABLE). Most xtures contain a built-in automatic, sound active or

custom program which is designed to operate with the xture NOT con

nected to a DMX chain.

Someoftheseprogramswillautomaticallyrununlessthextureissettoslave

mode.ThesexturestypicallysenseDMXautomaticallyandswitchtoDMXmode

upon receiving DMX signal (our Pucks do that!)

IfyouplugawiCICLE

“receiver”intoanautosensingxturesetasa“master,

“chancesaregoodthatthewiCICLE

“receiver” will begin transmitting the master

program. Most times, this is undesirable, and taking the two seconds to switch

these programs off will solve a lot of ails.

Got that done? Good! Then let’s proceed!

1.PlugthewiCICLE

Receiverintothe“DMXIN”connectorofthextureand

verify it is receiving power (the STATUS LED should illuminate.)

2.ConnecttheAC/DCadaptortothewiCICLE

Transmitter and verify it is receiv-

ing power (the STATUS LED should illuminate.)

3. Press the RECESSED SELECTOR BUTTON on the Transmitter to select the

operating channel group. (The system will store this setting for future use)

The7-ColorStatusLEDwillchangecolortoindicatethecurrentchannelgroup:

· GROUP 1: RED

· GROUP 2: GREEN

· GROUP 3: YELLOW

· GROUP 4: BLUE

· GROUP 5: VIOLET

· GROUP 6: CYAN

· GROUP 7: WHITE

4. Follow the same procedure on the Receiver to select the channel group.

5. Once both the transmitter and receiver(s) are both set to the same channel

group,connectthetransmittertotheDMXcontrollerortheDMXoutofaxture

on your DMX chain.

6.OnceaDMXsignalisprovidedtothetransmitter,thestatusLEDwillblinkRED

slowlyuntilcommunicationisestablishedwiththereceiver.ThestatusLEDon

thereceiver(s)willashGREEN slowly until communication is established.

7.Oncetheclearestchannelisauto-selected,thestatusLEDswillblinkquickly

onboththetransmitterandreceiver.NOTE:ThecoloroftheLEDDURING

operation does not indicate channel group, instead it indicates whether the unit

is transmitting or receiving. That’s It!

NOTE: “GROUP” number

also corresponds to the

“GROUP” setting on our

LightCaster™ wireless DMX

Transceiver.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Blizzard hotstik 5 cob Bedienungsanleitung Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Flutlichter Blizzard hotstik 5 cob